why should i have to check my math. It was down 7% I am looking at real time data not your delayed yahoo finances numbers
Do you feel warm inside? Yea lets all stick it to smallcap. I have no position in this stock yet. Im considering just shorting 2million shares to stick it you guys lol. But go ahead keep pumping it. More of a short profit for me when i leave you all bagholders
What a glorified piece of sht
have fun pumping. 100 stochastic level and 70 RSI? BS what an overbought POS. I remain commited to my 18cent entry when you guys get burned.
if you had read my post it needs to violate the .21 cent trend line. Its not my fault if some dumb people want to overpay.
Just telling it how it is. I predicted a 35% short move from the top. some would call that a victory...
Going against the trend can be fatal. Especially in a low volume environment.
To much of a bearish pivot point. above 22 cents. Not worth it. 1 more day of selling should put this name in the oversold category and it should create a bullish crossover at 18cents. Any professional would short anything above 22cents because of those bearish pivot points.
enought to violate the 0.21 support line and then you see a drift to 18 cents the bottom bollanger line should increase then you see a bullish crossover of the bottom bollanger band and the middle band right around 18-18.5 cents. If you look at the pivot points .22 cents is bearish territory for it and it means it has further downside.
the daily chart 14 cent bollanger indeed does say 14 cents. But the stock has enough momentum to never make it there. That and my institutional buddies will help support the fill in at 18 cents ;-)
NEWS FOR YOU IT 3D Printing companies are all software companies. Its the software that makes the hardware run. Most larger companies focus on both the hardware and software aspect.
tomorrow will be the 5th down day. You know that whole saying when you fail to achieve support and finish at the lower end of the range. It usually opens down. So what if my timing on certain calls is a little off. No one ever has perfect timing on stocks. You can't deny their is a downtrend in the macd though. Or that the stochastic is slightly above overbought. These are indicators you can turn on and look up foryourself. Just go to the yahoo finance interactive chart. Switch on technical indicators and you will be able to see everything more clearly. The downtrend is flattening out a little because shares are consolidating but with no news and less volume the stock only has to go down another 1/1000th of a point to break through .21 support. If it goes under .21 for any reason that will be a bearish crossover on the macd trend line and it will drift down to between 18-19cents near the bottom waap bollangar band line. I don't see substantial buying volume to support a drastic increase in the charts. that kinda of thing happens with news of which there are none. for everyone who held this name from .01 i applaud you. But for the moment i won't be a buyer until 18cents. I am not going to overpay despite what some of you pumpers may feel its worth (some not all of you). I am looking for established company fundamentals and more or less not trying to pay for the extra 3D printing premium attached with the title 3D printing company.
Sentiment: Strong Sell