FREMONT, CA--(Marketwire - Jan 22, 2013) - A major semiconductor discrete manufacturer has purchased an additional Surface Tension Gradient Dryer (STGD) from MicroTech because of its ability to dry thin wafers without damage to the wafer's thin films. This is the second order to the manufacturer by MicroTech, a Silicon Valley wet process station supplier.
The 200mm high-aspect ratio wafers utilize tape during processing because the wafers are so thin. The user has reported the following process performance of the STGD:
- Zero tape adhesive attack/undercut
- Zero tape adhesive residuals at edges of wafers
- Minimal contact or vibrations on thin wafers up to 50 micron thickness
- Minimal handling contact at load by the Teflon pushup bar fixture, a proprietary mechanism to "float" the wafers during processing.
MicroTech's Surface Tension Gradient Dryer utilizes Marangoni technology. The system uses very small amounts of IPA, approximately 5 ml, which is vaporized above the DI water during the process. The dryer has no moving parts, leaves no watermarks and completely eliminates the DI water from deep trenches and vias. At the end of the cycle, warm N2 dries the wafer cassette.
MicroTech is a leader in the engineering, manufacturing and applications support of wet process and chemical distribution equipment as well as on-site service, repair and maintenance. The company's 20,000 square foot Silicon Valley manufacturing facility is equipped with a Class 100 clean room fully facilitated with DI water and nitrogen for pre-shipment final testing. With over 25 years' experience as a semiconductor equipment manufacturer, MicroTech also supplies the solar, MEMS, LED, BioMed and flat panel display (FPD) markets. www.microtechprocess.com
- Nature & Environment
V.P. Sales and Marketing
510.651.5277 ext. 213